Tweet Does my new building need planning permission? The straightforward answer almost certainly is ”yes”. There are a few exemptions to the planning rules such as permitted development for smaller buildings in some domestic situations, temporary buildings (which means buildings that are up for less than 28 days), buildings which are like-for-like replacements of existing buildings, and [...]
TP Structures Ltd Articles & News
News and information about Industrial Buildings and Expandarange flat pack cabins and storesBrowsing Posts tagged Kit Buildings
Tweet Provision of rooflights is determined and constrained by frame arrangement purlin spacing, solar gain and daylight factor, and normally equates to approximately 10% of floor area. Rooflights can be single skin in the case of an un-insulated building or multi-layered to restrict heat loss where the building is to be insulated. All rooflights these [...]
Tweet Personnel doors are usually designed to be outward-opening and are usually made from steel for maximum durability and security. They are usually supplied primer-painted for customers to finish to their own requirements. Fire exit doors are of similar design and finish and are fitted with an internal panic latch or push pad but no [...]
Tweet Portal building kits are now available for self builds – spans up to 12m, and up to 5m eaves height. Fully galvanised lightweight steel frame. For full details see http://tpstructures.co.uk/industrial/portal_building_kits.htm
Tweet Roller shutter doors are the most popular and economic choice for goods doors. These will normally have galvanised laths and be hand operated by means of a chain. Options include electrical operation, coloured laths, Windlock guides and insulated laths, all of which incur additional cost. In general 0.6m (2ft) should be allowed above the [...]
Tweet You may often find reference to bays and bay size in relation to steel framed buildings. This refers to the distance between the stanchions (or columns). So a building 30m long might be divided up into five 6m wide bays with six rows of stanchions including two end gables. Each bay will span the width of [...]
Tweet STANCHIONS are the steel columns that form the upright posts in a portal framed steel building. They can be formed from heavyweight hot rolled steel “I” beam sections or from lightweight cold rolled galvanised steel “C” sections bolted back to back to form a strong composite “I” beam. The main stanchions should never be [...]
Tweet Baseplates are used to hold a portal framed steel building down to the foundation pads or base slab. They should be fabricated form steel plate comprising a thick bottom plate which is bolted to the concrete, with a welded upright to which is bolted the steel stanchion. The baseplate will normally resemble an upside down “T”.
Tweet The RIDGE is the highest point of the roof.
Tweet The EAVES of a portal framed steel building is defined as the distance from the floor level to the top of the steel frame on the side walls, i.e. the low point of the roof pitch.
